Ceiling Leak Drywall Repair in Pullman
A stain on the ceiling tells you the leak has already passed through the board. Once a plumber or roofer has stopped the water, we remove the damaged drywall, replace it and finish the ceiling.
Fix the source first
Drywall repair does not stop a leak. Before we patch anything, the water source has to be stopped by a roofer or plumber. A fresh patch over an active leak will stain again.
Once the source is fixed, we assess the board. Gypsum soaks up water and loses strength. A sagging ceiling, a bubble, or a soft spot that gives under light finger pressure means the board has to come out.
We cut back to dry, solid board and to the nearest joists so the new piece has a framing edge to fasten to.
Where ceiling leaks start
The stain shows where the water emerged, not always where it entered.
- 01
Roof leaks
Water follows rafters before it reaches the ceiling. Stains appear away from the roof opening.
- 02
Winter ice leaks
Ice that dams at the roof edge forces meltwater back under the shingles and into the attic.
- 03
Plumbing leaks
A supply or drain line in the attic or the wall cavity drips onto the board below.
- 04
Upstairs units
A tub overflow or a failed seal in the apartment above drops water straight through the ceiling.
Signs the board needs to be replaced
- A brown ring or stain that grows after rain or a hot shower
- A sag, bubble or bulge in the ceiling surface
- Paint peeling in sheets, or tape lifting at the seams
- A soft spot that dents when you press lightly
- A musty smell that returns after cleaning
- A stain that shows through repeated coats of ordinary paint
What Palouse winters do to ceilings
Pullman winters sit near or below freezing for long stretches, with snow in the cold months and occasional hard cold snaps. Snow on a roof melts from the heat that escapes through the ceiling, runs to the cold edge and refreezes. That freeze-thaw cycle pushes water under shingles, and the first sign is often a stain inside.
The median home in Pullman dates from the mid-1980s. Homes of that age often have original roof and attic details, so a ceiling stain in the cold months deserves a roofer's inspection.
About two-thirds of occupied homes in Pullman are rented. In multi-story rental buildings, a bathroom leak above one unit often shows up as a ceiling stain in the unit below.
What we check on site
- Moisture at the edges of the stain with a pin meter, to find where the board is dry
- Whether insulation above is wet and needs to be replaced by someone else
- Whether any board shows dark growth that a qualified specialist should assess
- The joist layout, so the new patch lands on framing
- Whether the ceiling is textured and what pattern it uses
A note on mold
We repair drywall. We do not test for or remove mold. If the board shows dark spots, fuzzy growth or a persistent musty odor, a qualified specialist should check it before anything is closed up. We will tell you when we see something that needs that check and we will wait for it.
Before we arrive
- Confirm the leak is repaired. Send us the plumber or roofer's note if you have it.
- Move furniture away from the damaged area and cover what remains.
- Photograph the stain from the floor and from a ladder if it is safe to do so.
- Turn off the power to a ceiling fixture that sits in the stained area.
Ceiling repair questions
Can you just paint over the stain?
A stain-blocking primer hides a dry, old stain. If the board is soft, sagging or still damp, painting only covers a failing ceiling.
Who should I call first, you or a plumber?
The plumber or roofer first. We repair the ceiling after the water is stopped.
Do you handle mold?
No. We cut out wet damaged board. A qualified specialist should check anything that looks like mold.
How long does a ceiling patch take to dry?
Most patches need two to three days of compound, sanding and primer, including drying time between coats.