Drywall Crack and Corner Bead Repair in Pullman
Cracks at doorframes, circular bumps in the wall and bent corner metal each have a cause. We fix the cause first, then rebuild the surface so the repair holds through the next season.
Three defects, three repairs
Each defect needs a different fix. A wipe of compound alone rarely lasts.
- 01
Cracks
Cut the crack open to a V, bed fresh tape, then build the surface in thin coats.
- 02
Nail pops
Drive a new screw beside the popped fastener, set the old one below the surface, and fill both.
- 03
Corner bead
Cut out the bent or crushed section, fasten new bead square to the corner, and finish it out.
Why cracks come back
A crack is the wall telling you something moved. Stress at doorframes and window corners, seasonal framing movement and hairline gaps at the ceiling line all open cracks. Filling the crack and painting does not give the wall any new strength.
We use paper or mesh tape bedded in compound across the full length of the crack. The tape spans the weak line and spreads stress over a wider area. Where a crack runs through a corner, we check whether the framing is shifting before we finish.
If a crack reopens within weeks and is widening, the cause is structural and a builder or engineer should look at it. We will tell you when a repair is outside what drywall can fix.
Signs to watch
- A diagonal crack running from the corner of a door or window
- A hairline crack at the seam between wall and ceiling
- Small round bumps with a crescent crack where a fastener has backed out
- Corner bead with a dent, a rusted edge or a visible bulge under paint
- Tape lifting along a seam
- Cracks that appear after a door slams or a heavy appliance moves
What this means in Pullman homes
Pullman sits in the Palouse, where the soil is fine wind-deposited silt called loess. Foundations on silty soil can move a little with seasonal moisture and frost, and the first place that shows is the drywall above a door or at a wall corner.
Many of the homes in the city sit on hillsides. Sloped lots and stepped foundations add to the movement that opens cracks, especially where additions meet original walls.
The median home was built in the mid-1980s. Wood framing keeps drying and swelling with the seasons for decades, and fasteners can work loose as it moves. That is why nail pops show up in houses of that age.
Apartment buildings take a different beating. Corner bead gets crushed by carts, furniture and bikes in hallways, and landlords see it year after year.
What we check
- Whether the crack is open at one end and closed at the other, which suggests movement
- Whether nail pops follow a stud line
- Whether corner bead is metal or vinyl and how far the damage runs
- Whether the texture needs blending after the repair
- Whether the same defect repeats on the opposite wall
Before we arrive
- Mark the cracks you want repaired with painter's tape.
- Move furniture away from corners and walls.
- Note when each crack appeared and whether it has grown.
- Send a photo of the largest crack with a coin beside it for scale.
Crack and corner bead questions
Are cracks above doors a sign of foundation problems?
Often they are ordinary framing movement. A crack that keeps widening, or one that comes with sticking doors, deserves a builder's opinion.
Can you fix a nail pop without repainting the whole room?
Yes. We patch and prime the spot, then your painter touches up. Matching sheen is the painter's call.
Do you replace corner bead or patch over it?
If the metal is bent or rusted, we replace the section. A skim over damaged bead leaves a visible hump.