Skip to content
Pullman Drywall RepairClean patches. Scheduled turnovers.

Drywall Hole and Dent Repair in Pullman

Doorknobs, chair backs, curtain rods and poster hardware leave the same marks in every rental. We match the repair to the size of the hole, so a small ding gets a skim and a fist-sized hole gets new board.

Damage we see most

Most calls fit one of these patterns.

  • Doorknob holes behind swinging doors with no stop
  • Gouges from furniture dragged along a wall
  • Pulled drywall anchors and torn paper around screw holes
  • Rows of small nail and tack holes from posters and frames
  • Impact holes from a fall, a kick or moving equipment
  • Crushed outside corners at hallway turns

How the repair changes with the hole

Size decides the method. Paint cannot fix a hole that a patch does not support.

  • 01

    Pin holes and small dings

    Fill with setting-type compound, sand flush and prime.

  • 02

    Holes up to about the size of a fist

    Back the opening with a patch plate, bed the patch in compound, then feather it wide.

  • 03

    Larger holes

    Cut to a clean rectangle, fasten new board to blocking in the cavity, tape the seams and finish in coats.

  • 04

    Torn paper facing

    Seal the exposed gypsum before mudding. Raw gypsum swells and bubbles under wet compound.

Why the second coat matters

A single heavy coat shrinks as it dries and leaves a dish. We build the patch in thin coats and let each one dry. The last coat feathers out past the repair so the edge disappears under paint.

We check the result with a light held along the wall, the same way a tenant or buyer would notice it. A patch that is flat to the hand but visible under raking light gets another pass.

Surface prep is part of the work. Dust left on the patch stops primer from bonding, so we vacuum and wipe before every coat of primer.

Pullman context

Student housing in Pullman turns over every year. Walls near doors, kitchen tables and bunked beds take the most abuse, and the same spots get repaired across successive tenancies. With about two-thirds of occupied homes in the city rented, that pattern repeats across thousands of units.

The median home was built in the mid-1980s. Walls in buildings of that age have taken decades of door swings and furniture moves, so the same spots near doors and corners keep getting damaged.

Moscow, Idaho sits about eight miles east, and the same rental cycle plays out there. We cover both sides of the state line.

What we check on every damaged wall

  • Whether the hole reaches a stud, wire or pipe before we cut anything
  • Whether the surrounding paper is loose or bubbled
  • Whether texture needs to be matched after patching
  • Whether similar damage appears on the opposite side of the wall
  • Whether the patch will sit under a door swing or outlet

Before we arrive

A short list for landlords and tenants.

  1. Clear furniture two feet away from the damaged area.
  2. Take two photos: one wide, one close up.
  3. Note whether the wall has texture, and whether it is rough or fine.
  4. Tell us whether the paint color needs to be matched by your painter.

Hole repair questions

Can a doorknob hole be fixed without replacing the whole sheet?

Yes. We cut a clean patch, back it, and feather the compound beyond the edge. The rest of the sheet stays.

Will the patch show after paint?

Not if the surface is built flat and primed. We check with raking light before we call the wall finished.

Do you charge by the hole?

We scope by photos and room count, then confirm the scope in writing before we start.

Damaged wall in Pullman? Send photos and we plan the repair.

CallText usEstimate